8
C. Pairing Bluetooth Headset with the Gateway
1. Make sure the Gateway is powered on and is in idle mode. That is, LED indicator
should be blinking every two (2) seconds.
2. Set the Bluetooth headset in its “pairing mode”. Please refer to your headset manufacturer
user documentation on pairing for the proper procedures.
3. The Passkey (Pin Code) of the Gateway has been pre-stored in factory as
0000.
4. Make sure your Bluetooth headset’s PIN code is the same as the Gateway has.
5.
Press the “Pair” button on the Gateway and release, LED indicator start blinking red
Within a few seconds, then LED Indicator shall flash both red and blue at the same time for
a very short moment, which indicates the pairing process are completed. You can also
check your headset LED to verify the status.
6.
After pairing has completed, Gateway returns to the idle mode regardless of whether
pairing has been successful or not. The LED indicator should flash blue every two seconds.
Remark :
1 It is recommends that proceed pairing in a secured arena.
2 The Gateway can be paired with up to 4 different headsets. The 5th pairing removes the
memory of the 1st one.
3. After paired successfully, the gateway will keep this pairing ID in memory even power
off. Once power on again, it work with paired device without re-pairing.
D. Making a Call
1. If your headset supports
Multi-Device ID Switch (e.g. BTH-101)
then select the line
