Dongle
Button
Battery
Cover
Battery
1. Install Dongle
Insert dongle and
plug it in as shown.
2. Connect Sensors
Insert plugs into
jacks #1 & #2.
3. Install Battery
Insert battery with
contacts on the right.
INSTALLING CONTROL BOX
3
4. Install Control Box
Slide the Control Box’s clip over the walker’s back support.
Adjust cable routing to avoid interference with moving parts.
Attach cables to wheelchair with ties (included)
Right
Hand
Sensor (#2)
Left
Hand
Sensor
(#1)
Control
Box
Walker
Back
Support
INSTALLING
COMPONENTS
1
Control Box
2 Sensor Unit Arms
2 Batteries
(+ charger)
Dongle
(+ charger)
Headset
The headset is already paired but you can use your own headset (follow manu-
facturer’s instructions ). To pair the headset to the dongle if needed press and
hold dongle power button until dongle light flashes
blue
and
red
(6 seconds).
Release the power button. Place your headset within 3 feet of the dongle and
press and hold its power button until light flashes
blue
and
red
for 3 seconds.
Release headset power button and wait for devices to pair (~1 min.)
CAUTION: The system must be used only according to directions and procedures described here. Avoid looking
straight into the lower sensor when the power is turned on. Turn it off when not in use. Do not leave within the
reach of children.
INSTALLING SENSOR ARMS
2
Left
Sensor
Arm
Right
Sensor
Arm
Screw
1. Install Sensor Arms
Snap sensor arms onto
front frame. Insert and
tighten the clamp screw.
