KEYPAD OPERATION
The keypad has two output relays, which can be controlled separately using the
# key or * key following the 4 digit code
Example :
Enter 1234# to pulse Relay 1
Enter 1234* to pulse Relay 2
You will then hear 5 short beeps together with 5 flashes of the keypad buttons
to indicate that a correct code has been entered.
If you enter an incorrect code you will hear 1 long beep and the keypad will
flash, if you enter an incorrect number you will need to wait for 3 seconds for
time out - there will be one beep and one flash of the keypad and the unit will
reset back to the beginning where you can reenter you 4 digit code again.
Toggle / Latching Relay
You can latch relay 1 or 2 ON.
You can do this by entering your 4 digit code and then
holding down the
star(*) or hash (#) key for 5 seconds
, this will latch the relay on.
To release the relay just type in your 4 digit code and momentarily push * or #
Administration Mode:
This is where you are able to manage your 4 digit codes and change settings
i.e. relay pulse time, change admin code etc
PLEASE NOTE YOU WILL NEED TO ENTER ADMINISTRATION MODE
WHEN FIRST POWERED UP TO SET YOUR 4 DIGIT CODE
Page 2
