Technical Documentation G.Mondini S.p.A. Tray Sealer TRAVE-350
5
Change Over
A full change over of the tray sealer can be done in ten minutes. All parameters are menu driven, in
this way the skill requirement is very low. Both bottom and top tool slide out of the chassis of the
machine. The top and the bottom tool are locked and unlocked through a pneumatic quick release
system. No lifting is required by the operators.
Performances
The product and the packaging material will determine exactly the cycle time. However, as a
reference, we consider the following table of cycles per minute.
Type of Product
Heat Seal
Pre Cut Lid
V&G
G Closure
L Closure
Solid
17
15
14
17
16
Liquid
10
10
8
10
10
Maintenance
Being mainly a mechanical machine, all bearings, bushing, shaft etc need to be greased regularly.
Each tool has its own greasing point.
Mechanical Specifications
Electrical Motors: Coel.
Gear Box: STM
Drum motor: Interrol
Belts: Habasit
Pneumatic Specifications
Metalwork
Health and safety
The machine is CE marked and comes with declaration of conformity.
