User Manual V1.0
Tel: +49 (0) 7248 927400
www.G-LEC.com
4)
The Manager contains 16 numbered outputs. Connect the first output to the
first Bracket in line. This will be fed the first pixel information from the mapping
in the S-Drive II Video Processor. This connection is made using a shielded CAT-5 cable.
Connect output to the second Bracket in line, continuing until the maximum of 16
outputs are used. If you wish to connect further brackets, then a second
Manager will be required.
5)
Using a compatible fibre optic cable, connect the output of the S-Drive II to the input of
the Manager on the right hand side of the unit. These connectors are keyed, so
need to be inserted the correct way around, but they simply push in to lock. To remove
them, pull gently on the side of the connector only, and it should release. The S-Drive II
will normally sit at your video control position and therefore the use of fibre optic cable
allows the fast transmission of data across longer distances.
6)
Should you need to connect further Manager boxes, they can be daisy chained
using further fibre optic cables, connecting the output of the first, to the input of the
next, and so on.
7)
Connect your desired configuration of Lines to the Brackets. The
connection between these two elements is via a keyed 4 pin connector. Ensure that
both connector components are correctly aligned and push them together. The male
side of the connector has a locking ring which needs to be turned a quarter turn
clockwise until you feel it physically ‘click’ into place and will not turn further. Once
‘clicked’ a firm connection has been made. To undo these connectors, turn the locking
ring anti-clockwise a quarter turn before attempting to pull the connector apart.
Sequential Lines can be connected using the same method.
8)
Each Line has a tab at the first and last sphere. These are for the specific
purpose of attaching a secondary safety wire, and must be used at the point where a
Line connects to a Bracket. Further safety cables should be used where
systems are placed above people or objects which may be damaged.
9)
Connect mains power to the Manager, PSU and S-Drive II units via their power
inputs. Turn on all units via their onboard switch.
10)
Connect a DVI-D source to the input of the S-Drive II and configure the S-Drive II for your
desired layout. For further information, consult the S-Drive II user manual.
Once configured, your system will play back the signal being fed and distributed via the
S-Drive II.