C
- 9 -
© G.i.N. GmbH, 2018
Intelligente Datenlogger
Network Camera (HostCAMF44) Manual
3
Camera Settings
The camera can be configured with a standard web browser using any PC, if it is connected to the camera´s
network via Ethernet. To use the Web interface, the IP address of the camera must be entered in the
address area of the browser.
To adjust the camera, the sensor unit must be connected to the control unit. If it is
replaced afterwards, some settings will be erased or reset.
By default, the camera IP address is set to: 192.168.0.90. To access the camera, the IP address of the PC
must be in the same network area. A configuration example:
Camera
PC
IP address
192.168.0.90
192.168.0.100
Subnet mask
255.255.255.0
255.255.255.0
When the camera is accessed for the first time, the password needs to be set for the default administrator
user “root”. Thereafter, every access requires the user name and the password.
Figure 2
Afterwards, the capture mode needs to be set for every sensor unit individually. Depending on the desired
resolution and image quality, the frame rate can be set here. Changing it afterwards for every sensor unit is
also possible. Only the frame rate of the connected action rules need to be adapted (see chap. 3.6 & 3.5).
Figure 3
When the login details are set, please select the power line frequency (50 Hz or 60 Hz) used at the location
of the product.
Selecting the wrong frequency may cause image flicker if the product is used in environments with
fluorescent light.
