BlueTexGPS Mobitex Integration guide v.2.6
13
USING THE CONTROL PANEL
Below is a screendump of the BlueTexGPS control panel.
Connect
To connect to a BlueTexGPS unit select the serial port that the Bluetooth device give
you. Press the Open button and wait. When connected the units manid and the
software information will be showed. If you connect to the unit to soon after power on
you may get a invalid manid (negative) from the unit. Press the Update button to
refresh the information.
The settings
The Receiver MANID is the manid of the unit you want the unit to send its information
to. Update interval is the time between the pospac generated. If you don’t select
staffling on one message will be sent to the receiver manid every time a pospac is
created, if you select staffling on one message will be sent when there are a selected
number of pospacs in the unit. In the screenshot 28 is selected.
The update interval is the time between the captured positions. It is not possible to
set it less then 10 sec.
Every pospac will be sent with a payload. The payload for each button is defined bit
wise in the payload fields, every byte will be calculated and shown as a hex number.
If the checkbox for the button is checked the button will keep its payload in the
memory and make the unit send it as default until the button is pressed ones more.
Mobitex mode makes a direct connection between the serial port (Bluetooth) and the
mobitex modem. This mode is for configuration of the mobitex modem. When the unit
reboot it will go back to normal mode.
