24
5) Finally, push the carriage all the way to the left to seal printheads by the PE cling film (Figure 5-7).
The nonwoven fabric and PE wrap film have to be changed everyday
Figure 5-7
Please move the capping cover away before turning on the printer.
5.5 Short term shut down (3~7 days)
1
）
Disconnect the tube connector for the tube from the Subtank to the printhead. Wait until the
ink finishes dropping, and then, connect the tube to the solvent tube. Press both of the flush
buttons to clean the printhead with solvent. Stop until the solvent becomes clear nearly.
2
）
Use tube cover to seal the ink incoming tube for the printhead. Use fresh wrap to cover the
nozzle surface. Then, push the carriage all the way to the left to seal printheads by the cap.
5.6 Long term shut down (More than a week)
1
）
Clean the whole ink supply system by solvent.
2
）
Disconnect the tube connector for the tube from the Subtank to the printhead. Wait until the
solvent finishes dropping almost. Use tube cover to seal the ink incoming tube for the
printhead. Use fresh wrap to cover the nozzle surface. Then, push the carriage all the way
to the left to seal printheads by the cap.
Attention
：
For keeping the ink supply system clean, please replace the filter every 4 months.
Chapter 5 Maintenance Guide