10
TIP FOR DRILLING HARD SMOOTH SURFACES
Place a piece of masking tape onto the surface in the
approximate position for the hole. Mark the position of
the hole onto the masking tape this will prevent the
drill from skidding across the surface when the drill is
started. Slowly drill through the surface.
TIP FOR DRILLING METAL
When drilling metal, use a light oil on the drill bit to
keep it from overheating. The oil wil prolong the life of
the bit and increase the drilling action.
TIP FOR MASONRY DRILLING
For maximum performance, use carbide-tipped
masonry impact bits when drilling holes in brick, tile,
concrete, etc.
For maximum performance, use high speed steel bits.
Apply light pressure and medium speed for best
results in brick.
Apply additional pressure for hard materials such as
concrete.
WORKPIECE CLAMPING
To prevent the drill bit from spinning the work piece if
the drill bit becomes jammed in the hole being drilled,
it is recommended that a drill vice or other suitable
clamp is used to secure the work piece during the
drilling operation.
If the bit jams in the workpiece or if the drill stalls,
stop the tool immediately. Remove the bit from the
workpiece and determine the reason for jamming.
Note: This drill has an electric brake. When the switch
trigger is released, the chuck stops turning. When the
brake is functioning properly, sparks will be visible
through the vent slots on the housing. This is normal
and is the action of the brake.
MAINTENANCE
This power tool normally requires no maintenance;
from time to time the ventilation slots on the motor
casing should be cleaned out. If the unit should
become defective, repair should be performed by an
authorized service agent for electric tools.
Avoid using solvents when cleaning plastic parts.
Most plastics are susceptible to damage from various
types of commercial solvents and may be damaged
by their use. Use clean cloths to remove dirt, dust, oil,
grease, etc.
Warning! Do not at any time let brake fluids, gasoline,
petroleum based products, penetrating oils, etc.,
come in contact with plastic parts. Chemicals can
damage, weaken or destroy plastic which may result
in serious personal injury.
TECHNICAL SPECIFICATION
CHARGER
Voltage
18V DC
Capacity
2.0Ah
Charge time
3-5 hours
Cell type
Lithium-ion
No load speed
0-350min
-1
(low)
No load speed
0-1400min
-1
(high)
Torque settings
19+1
Maximum torque
25Nm
Keyless chuck size
10mm
Drilling capacity (wood)
25mm
Drilling capacity (steel)
10mm
Sound Pressure Level
L
pA
72.3 dB(A)
K=3dB(A)
Sound Power Level
L
WA
83.3 dB(A)
K=3dB(A)
Vibration Level
3.0 m/s
2
, K=1.5m/s
2
Voltage
230V~50Hz
Output voltage
21V DC 400mA
