FXA FXAJD2835, Instruction Manual, Page: 9 / 56

9
MAINTENANCE
Warning! To avoid accidents always disconnect the
tool from the power supply before cleaning or
performing any maintenance.
This power tool normally requires no maintenance;
from time to time the ventilation slots on the motor
casing should be cleaned out. If the unit should
become defective, repair should be performed by an
authorized service agent for electric tools.
The tool may be cleaned most effectively with
compressed dry air. Always wear safety goggles when
cleaning tools with compressed air.
Ventilation openings and switch levers must be kept
clean and free of foreign matter. Do not at tempt to
clean by inserting pointed objects through openings.
Avoid using solvents when cleaning plastic parts.
Most plastics are susceptible to damage from various
types of commercial solvents and may be damaged
by their use. Use clean cloths to remove dirt, dust, oil,
grease, etc.
WARNING! Do not at any time let brake fluids,
gasoline, petroleum based products, penetrating oils,
etc., come in contact with plastic parts. Chemicals
can damage, weaken or destroy plastic which may
result in serious personal injury.
Electric tools used on fiberglass material, wallboard,
spackling compounds, or plaster are subject to
accelerated wear and possible premature failure
because the fiberglass chips and grindings are highly
abrasive to bearings, brushes, commutators, etc.
Consequently, we do not recommended using this
tool for extended work on these types of materials.
However, if you do work with any of these materials, it
is extremely important to clean the tool using
compressed air.
LUBRICATION
All of the bearings in this tool are lubricated with a
sufficient amount of high grade lubricant for the life of
the unit under normal operating conditions. Therefore,
no further lubrication is required.
TECHNICAL SPECIFICATION
Voltage 230V - 50Hz
Motor 480W
No load speed 800-3000 min -1
Max. cut in wood 65mm
Max. cut in steel 6mm
Cutting angles 0º/15º/30º/45º
Sound Pressure Level L
pA
87 dB(A)
K=3dB(A)
Sound Power Level L
WA
98 dB(A)
K=3dB(A)
Vibration Level a
h,B
=8.571 m/s 2 ,
K=1.5m/s 2
a
h,M
=6.834 m/s 2 ,
K=1.5m/s 2