FXA FXA92502, Instruction Manual, Page: 12 / 104

12
42 Always store the push-stick when it is not in use.
43 Pay particular attention to instructions for
reducing risk of KICKBACK. KICKBACK is a
sudden reaction to a pinched, bound or
misaligned saw blade. KICKBACK causes the
ejection of the work piece from the tool back
towards the operator.
KICKBACKS CAN LEAD TO SERIOUS
PERSONAL INJURY. Avoid KICKBACKS by
keeping the blade sharp, by keeping the rip
fence parallel to the blade, by keeping the riving
knife and blade guard in place and operating
properly, by not releasing the work piece until you
have pushed it all the way past the blade, and by
not ripping a work piece that is twisted or warped
or does not have a straight edge to guide along
the fence.
44 Avoid abrupt, fast feeding. Feed as slowly as
possible when cutting hard work pieces. Do not
bend or twist work piece while feeding. If you stall
or jam the blade in the work piece, turn the tool
off immediately. Unplug the tool. Then clear the
jam.
45 Before turning over the tool, always make sure
that the stopper pin has securely locked the tool
head in the lowest position.
1. Riving knife
2. Fixing pin for cutting blade shield
3. Cutting blade shield
4. Locking button for cutting blade tilt lever
5. Cutting blade lift/lower knob
6. Locking lever for cutting blade tilt
7. Cutting blade bottom shield
8. Switch
9. Power cord holder
10. Ripping fence fixing screw
11. Work table rotation locking lever
12. Work table
13. Ripping fence
14. Cutting blade
15. Crosscut fence
16. Crosscut fence fixing knob
17. Locking knob of the mitre gauge
18. Mitre gauge
19. Wheel
20. Holder for push stick
21. Leg locking knob
22. Leg
23. Adjustable foot
24. Mitre gauge slot
25. Angle scale for cutting blade tilt
26. Cutting blade tilt indicator
27. Ripping fence fixing knob
28. Head locking pin
29. Table rotation locking knob
30. Fence
31. Turntable
32. Angle scale of turntable
33. Carbon brush cover
34. Movable shield
35. Riving knife fixing knob
36. Dust bag
37. Dust extraction outlet
38. Stationary shield
39. Movable shield locking lever
40. Switch lock button
41. Handle grip
42. Switch
43. Vertical clamp locking knob
44. Vertical clamp
45. Vertical clamp locking lever
46. Head position locking lever
47. Limiter
48. Spindle lock lever
COMPONENTS & CONTROLS (FIG.1 TO 1C)
TABLE SAW ITEMS MITRE SAW ITEMS
* Differences may appear between the product
and drawing.