FXA 501585733, Instruction Manual

Page: 12 / 55

- 12 -
Filter replacement
WARNING
:
To reduce the risk of injury from accidental starting, unplug power cord before
changing or cleaning filter.
IMPORTANT:
After cleaning, check the filter for tears or small holes. Do not use a filter with holes or tears
in it. Even a small hole can cause a lot of dust to come out of your vac. Replace it immediately.
WARNING
:
Do not remove filter cage and float. The float prevents water from entering the
impeller and damaging the motor. The cage prevents fingers from touching the moving impeller.
Cleaning
To keep your wet/dry vacuum cleaner looking its best, clean the outside with a cloth dampened with warm
water and mild soap. To clean the tank:
Dump out debris.
2. Wash tank thoroughly with warm water and mild soap.
3. Wipe out with dry cloth.
Storage
WARNING
:
Before conducting any maintenance or cleaning, switch off and unplug the
appliance. If the mains plug is plugged in, the appliance could accidentally be switched on, resulting in
injuries.
-
Release both retaining clips at the canister and remove motor housing from the canister by means of
the carrying handle and set on side.
-
Empty the container.
- Replace or clean the filters after wet vacuuming, thoroughly dry the interior of the appliance and any
wet accessories (nozzles, suction hose, suction tubes, etc.) and only then install the desired filters.
-
Install the motor housing on container and fasten the retaining clips.
-
The appliance, accessories and container should, however, be cleaned with a moist cloth when
required. When doing this, take care to ensure that no electrical components come into contact with
water.
Check the hoses and connections and check the mains lead for any damage.
The power cord should be wrapped and hung on the unit and the accessories should be kept in the
accessory holder so they can be readily available.
Store the equipment and accessories out of children’s reach in a dark and dry place at above freezing
temperature. The ideal storage temperature is between 5 and 30 °C. Store the electric tool in its original
packaging.