Section 50
00-02-1032
2020-12-08
-
4 -
M-VIEW Touch Series Display Features
The display module is a highly integrated operator interface specially programmed to complement and support the
Centurion controller. The primary purpose of the display is to:
view controller operational information;
view/edit controller operational parameters;
send commands to controller, such as stop, edit and reset.
State and Mode of the Controller
Depending on the configuration active in the controller, the operation may differ depending on what Mode the
controller is currently displaying.
The Mode can be changed by touching certain icons if the configuration allows for Remote mode.
Touching Reset or Run/Stop is a Local function and will change the Mode to Local if in Remote Mode.
Touching the Fn icon before touching Reset or Run/Stop is a Remote function and will change the Mode
to Remote if in Local Mode.
The top left of the screen displays the Centurion operating state. Displayed next on the top line are active timers,
the run hour meter and the panel starting mode as Local or Remote. The top right displays the system (Centurion)
being displayed. This information is key to understanding the status of the controller.
FN Screen
Touch the Function (Fn) icon to display the Function Menu pop-up with available function command screens.
Touch a function command screen from the menu to open it.
The function menu will time out in 5 seconds if a selection is not made.
A prompt to enter a password may appear for some screens to open.
When in Remote Mode:
Remote mode commands are available only while the Fn icon is pressed.
