FuzzDog DeathDrive, Manual

Page: 6 / 16

Initial wiring
USE WIRES! Our ribbon cables are unlikely to be of any
use unless you’ve compromised your enclosure layout to
line up the pads to daughterboards.
If you aren’t going to use a footswitch to engage/bypass the OCTAVE section of the
circuit, add a jumper as shown below.
...otherwise add wires to all five of those pads. OV is for +supply, OG is ground.
O1 is Octave Bypass
O2 is the input to the Distortion section
O3 is Octave Out
Add long wires to the other two sets of pads for offboard wiring.
BOOST OCTAVE DISTORTION