Implementation
There are no hard and fast rules about implementing this tone circuit. How it is
incorporated into an existing circuit depends on what that circuit is. You’ll get different
results from it being positioned in different places in a circuit. We’ll give some
examples, but it’s really up to you.
To replace the tone control in our Rodent:
Leave out the Filter pot and C8. Jumper R6.
Connect the BMP Tone IN pad to FILT pad 1, OUT to FILT pad 3.
If you were to use a version with gain recovery you’d also need to connect the 9V and
GND pads to the supply.
To add tone to the end of a circuit, i.e. our Sunny-T:
Don’t connect pin 3 of the volume pot.
Connect the BMP Tone IN pad to Volume pad 3, OUT to pin 3 of the volume pot.
Again, 9V and GND connect to supply if you’re using gain recovery.
