FUZION V1000 LITHIUM POWERED
owner’s manual
8
BATTERY CARE:
Be sure to charge the scooter after every use. Allow the light on the charger to turn green
indicating a full charge before disconnecting. Do not leave the charger sitting plugged into the
wall or scooter for extended periods of time (more than 24 hours). Not following these guidelines
can result in damage not covered under the manufacturer’s limited warranty.
CHARGING:
Before charging, ensure the scooter is switched off, then open the cover on the charging socket
near the front of the scooter on the kickstand side. Connect the charger plug to the charging
socket (see the section “component overview” for location of the charging socket on the V1000).
Now connect the charging unit into the wall outlet. The battery is charging while the charger LED
is red. The charger LED will become green when it is fully charged. To stop charging, remove the
plug from the power outlet, then remove the circular plug from the scooter’s charging socket.
WARNING:
BE SURE TO FULLY CHARGE THE SCOOTER PRIOR TO LONG TERM STORAGE.
WHILE IN STORAGE IT IS MANDATORY TO FULLY RECHARGE THE BATTERY EvERY
MONTH. NOT RECHARGING THE BATTERY, WHEN NOT REUSING THE SCOOTER OvER
ExTENDED PERIODS (4 WEEKS) WILL CAUSE SEvERE DAMAGE TO THE BATTERY.
ATTENTION: AFTER CHARGING HAS COMPLETED REMOvE THE CHARGING UNIT FROM THE
WALL OUTLET AND SCOOTER CHARGING SOCKET. THIS MUST BE COMPLETED AFTER EvERY
CHARGING OPERATION. FAILURE TO REMOvE AND RECONNECT THE CHARGER FROM THE
WALL OUTLET WILL CAUSE A NO CHARGE CONDITION. THIS WILL BE A GREEN CHARGE
INDICATOR LIGHT WHEN CONNECTED BUT CHARGING FUNCTION IS NOT PREFORMED.
DISCONNECT THE CHARGING UNIT FROM THE WALL OUTLET FOR 1 MINUTE THEN
RECONNECT TO INITIATE CHARGING OPERATION.
