Original User Manual FX-AF1139_rev03
14
6.4.2.2.
STARTING WITH A HOT ENGINE
Place the device on a level and stable surface to start it.
-
Move the throttle lever into
position.
-
Stand behind the device and pull the starter rope until
the engine starts.
-
Set the appropriate number of revolutions with the
throttle lever.
6.4.2.3.
STOPPING THE ENGINE
-
Move the throttle stick to the position and
leave the engine idling for a few seconds.
-
Move the throttle stick to the "STOP" position.
6.4.3.
CONTROL POINTS AFTER STARTING THE
ENGINE
It is essential to pay attention to the individual parts or
the device's temperature. If you find an anomaly in the
device, stop immediately and check it carefully. In case
of a malfunction or problem, take the device to a service
technician for repair. In any case, continue to use the
device if the operation does not appear to be correct.
Do not use the device if it is damaged or improperly
adjusted.
7. USE OF THE DEVICE
Use this device only for the intended purposes.
Using this tiller for other purposes is dangerous and
may cause personal injury and damage to the device.
Do not approach the rotary tiller's cutting tools when
the engine is running.
Do not start the device in a closed room, as the exhaust
gases and fuel and oil vapours contain carbon monoxide and
harmful chemicals.
In the event of an increased
concentration of gases caused by poor ventilation,
remove anything that impedes clean airflow to improve
ventilation from the work area. Do not return to the
work area unless you have a properly ventilated area
and know that ventilation is adequate so that this
increased concentration will not occur again.
Work only in daylight or good artificial light. Do not use
this device at night, in fog or poor visibility. Otherwise,
the working area will not be visible.
Limit the further use of this system to a time limit of 10
minutes and pause 10 to 20 minutes between the
individual work phases.
If you slip or fall, stop the acceleration and move the
switch to the "STOP" position.
Do not use this device if you are tired, sick, on drugs,
narcotized, or addicted to alcohol. Lack of rest and
fatigue can cause accidents or damage.
Always adjust the device on a level and stable surface.
Do not use the device on steep slopes to not guarantee
safety. When working on a hill, slow down your working
speed and ensure good stability.
Be careful when pulling the device
towards you.
Do not rely solely on the safety features of this system.
It is necessary to pay attention to the possible loosening
or overheating of device parts. If you find an anomaly,
stop the device immediately and check it carefully. In
case of mechanical failure, contact the technical repair
service.
You should not continue working if you find that the
process is not running correctly.
Remember to always use the device with clean hands
and without fuel or oil residues.
Clean the working area and remove all obstacles that
could lead to accidents. Check the working area while
working and remove all objects that could get caught in
the cutting tool. Also, remove any items that the cutting
tool may eject forcibly during the operation.
Do not let anyone enter the work area. This work area
must be 15 meters long and is a danger zone.
Never leave this device unattended.
Take care not to touch hot parts of the device while
the engine is running or after use, e.g., exhaust,
spark plug, or high voltage cable.
Please do not use any accessories for
this device other than those
recommended by our company. Such
use may cause severe damage to the user, persons in
the vicinity of the device, and the device itself.
Always follow the safety instructions in this manual.
7.1.
HOLDING AND OPERATING THE
DEVICE
When working, always stand behind the
device and hold it with both hands on the
handles.
