Original Manual 120V trimmer_rev03
22
Switching off
Release the On/Off switch.
Battery state indicator
The battery state indicator show the capacity of the battery.
The indicator goes out after 5 seconds.
If one of the LEDs flashes, the battery must be recharged. If none of the LEDs light up after the
button is pressed, the battery is faulty and must be replaced.
Automatic line release
You can release the cutting line without stopping the motor.
To release more cutting line, gently tap the cutting head on the ground while running the line
Trimmer. The line blade in the guard cuts the line back to the correct length if too much cutting
line is released. It is best to bounce the cutting head on bare ground or hard earth.
Work instructions
Attach the shoulder belt to the unit. Pull the shoulder belt over your head.
Hold the unit with both hands: one hand on the rear handle, the other hand on the handlebar.
Keep the cutting attachment parallel to the ground and make sweeping movements from side
to side.
Walk slowly forwards.
Use only the tip of the line for cutting, especially along walls. If more than the tip is used for
cutting, the cutting capacity is reduced and the engine may overload.
Cut grass which is taller than 20 cm from the top down in small stages to prevent premature
wear of the line and engine resistance.
Cut dry grass and weeds only.
The trim line may break by: