00077901.DOC, Version 1.0
40/52
Please, be sure that you don’t have any overlapping channels in order to control each PLB-130 correctly and
independently from any other fixture on the DMX-chain.
If several PLB-130 are addressed similarly, they will work synchronically.
Press the Up/Down-buttons for setting the desired starting address. Now you can start operating the PLB-
130 via your lighting controller.
Note:
After switching on, the device will automatically detect whether DMX 512 data is received or not. If there is
no data received at the DMX-input, the display will flash.
This situation can occur if:
- the XLR plug (cable with DMX signal from controller) is not connected with the input of the device.
- the controller is switched off or defective, if the cable or connector is defective or the signal wires are swap
in the input connector.
