FDC_C-Series_Quick_Operation_User_Manual_UMQOC621A.doc Page
2
of
20
Quick Operation Manual C22/C62/C82/C83/C72/C42/R22
1. DISPLAY AND KEYS:
During power-up, the upper display will show PROG and the lower display will show the Firmware version for 6 seconds.
SCROLL/ENTER KEY:
This key is used to select a parameter to be viewed or adjusted.
Press
for the next parameter. Press
and
key for return to the previous parameter.
UP KEY:
This key is used to increase the value of the selected parameter.
DOWN KEY:
This key is used to decrease the value of the selected parameter.
RESET KEY:
This key is used to:
1. Revert the display to the home screen.
2. Reset a latching alarm once the alarm condition is removed.
3. Stop manual control mode, auto-tuning mode or calibration mode.
4. Clear an auto-tuning or communication error message.
5. Restart the dwell timer when the dwell timer has timed out.
6. Enter the manual control menu if failure mode occurs.
2. MENU FLOWCHART:
5 Sec
6.2 Sec
7.4 Sec
8.6 Sec
9.8 Sec
5 Sec
5 Sec
2~3 Sec
User Menu
Setup Menu
Manual Mode Auto-Tuning Mode
Calibration Mode
SCROLL/ENTER KEY:
1. Press and hold
for 5 seconds, display will show
. Press
to enter the Setup Menu.
2. Press and hold
for 6.2 seconds, display will show
. Press and hold
for 5 seconds to enter Manual Mode.
3. Press and hold
for 7.4 seconds, display will show
. Press and hold
for 5 seconds to enter Auto-Tuning Mode.
4. Press and hold
for 8.6 seconds, display will show
. Press and hold
for 2~3 seconds to enter Calibration Mode.
2.1 User Menu:
The below user menu
parameters are available depends on
user’s selection.
2.2 Setup Menu:
The setup menu has
been categorized into eight categories
as below.
1. bASE:
Basic Menu
2. oUT:
Output Menu
3. ALRM:
Alarm Menu
4. EI:
Event Input Menu
2.2.1 Basic Menu (bASE):
Use
or
key to get bASE in the lower
display, then use
key to enter basic
menu parameters.
