3. Lift the handset and place on side. Do not listen to the handset when
programming as you may hear some announcements. This is normal.
NOTE: ONCE YOU START PROGRAMMING YOU MUST NOT HESITATE
AS THIS MAY CAUSE THE NUMBER NOT TO BE PROGRAMMED….
4. Press and release STORE button.
5. Press the
0-9
keys for the telephone number you wish to store including area
code if needed.
6. Press and release the STORE button again.
7. Press the priority key M1 or (0-9) (pictures) where you want that telephone
Number stored in.
8. Your number is now stored.
9. Replace handset.
10. To change a stored number, repeat the same process. The new number
Will store over the old stored number.
A Memory Index Card is provided for your use in writing down the person‘s name.
Note: If you need to disconnect the 911 key you may program any other number
you wish or just the digit “1” into this key by following the above points 1-5 push
the 911 key for point 7 then points 8-9.
To Retrieve Memory Numbers
A. Priority Keys:
The priority key M1 is the one touch direct call key button. Pick up the handset and
depress the priority key M1 button which stores the telephone number you want to
dial. Your call will be automatically dialed.
B. Key button Memories:
Your phone provides the option
of
“Normal” or “One Touch”
dialing mode.
Normal mode
- To retrieve numbers stored in the key button,
pick up the handset and press the PHOTOCALL button.
Then press the key button number (0-9) (pictures) which stores the
telephone number you want to dial. Your call will be automatically dialed.
One Touch mode
- To retrieve numbers stored in the key button, Pick up the
phone and wait for a dial tone, then press the key button (pictures) which stores
the telephone number you want to dial. Your call will be automatically dialed.
Please note:
–
Original Two touch memories will become one touch memories at ONE
TOUCH mode
–
There will be no dialing (0-9) function when the ONE TOUCH mode is
selected
–
You can not program any memories when in ONE TOUCH mode
Inserting Pictures (Photos)
1. Remove numbered plastic cover from each key 0-9.
2. You will need a pictures approximately 1” x 1” inch.
3. Place picture into key.
4. Replace plastic cover.
