Page 3 of 5 // email [email protected] US tel +1(603) 742 9181 Europe tel +44 (0) 1438 833577
ii.
Press the [STORE], [<] or [STORE], [>]. This will set the left or right
maximum rotations respectively.
iii.
To clear the maximum left rotation, press [STORE], [STOP], [<]
iv.
To clear the maximum right rotation, press [STORE], [STOP], [>]
v.
Test the new left and right rotational limits using the [<] and [>]
buttons.
6.
Set the intermediate viewing angles (if required.
i.
Position the swivel at the required maximum rotation using [<], [>]
and [STOP] on the IR remote.
ii.
The following commands will save this position as one of the 4
available viewing angles
1. [STORE] [PRESET]
2. [STORE] [A]
3. [STORE] [B]
4. [STORE] [C]
iii.
Intermediate viewing angles cannot be cleared, only repositioned
iv.
Test the new intermediate viewing angle using the [PRESET]. [A],
[B] or [C] buttons as appropriate.
Swivel Recovery
In some circumstances it is possible for the software within the unit to lose track of
where the swivel and telescope are. This will typically happen if replacing a control
board of software chip whilst the swivel and telescope are mid-travel, or if there is a
power cut whilst the swivel or telescope are moving, In these circumstances, the
software may go into a protective shutdown state and will not respond to user
commands. To recover from this,
1.
Enter
[STORE] [STORE] [>]
on the Future Automation remote control,
sequentially with no more than 2 seconds between each press
2.
From this point you will be able to move rotate the swivel left and right in short
bursts using
[<]
and
[>]
3.
Position the swivel at the HOME (centred) position
4.
From this point you will be able to press [IN] to retract and fully reference the unit
