6
Binder Connector From Sensor
The ± Excitation and ± Signal pins are used for
mV/V non-amplified output sensors.
For six wire sensors with ± Sense, the ± Sense
connections should be connected to the
± Excitation connections respectively.
For amplified output sensors, the selectable 24V
Output and Ground pins can be used to power
the sensor, and the ± Amplified pins can be used
for Voltage or Current outputs from the sensor.
The 4.75V Output and Ground pins can be used
to power circuits, such as encoders in our rotary
torque sensors.
The Leading Pulse and Lagging Pulse pins can be
used with the Ground pin for encoder outputs.
Typically our rotary torque sensor encoders will
have Angle 1 on the Leading Pulse pin and Angle
2 on the Lagging pulse pins.
If the Leading Pulse, Pin L, leads Pin M the
encoder count will increase, and if the Lagging
Pulse, Pin M, leads Pin L the encoder count will
decrease.
G
M
F E
D
C
L
B
A
K
J
H
The USB520 Spec Sheet can be found here:
https://media.futek.com/content/futek/files/pdf/
productdrawings/usb520.pdf