MULTICROSS 3D COMPACT
5
ON: H
1x: V1
2x: V1 + V2
3x: H + V1 + V2
H
V
2
V
1
3 sec.
&
MANUAL
Horizontal and vertical alignment
After releasing the transportlock, and provided the instrument is within its levelling
range, the horizontal line is automatically levelled. You can activate or deactivate the
horizontal and vertical lines using the H/V-button
(8)
.
In order to use vertical lines, press the H/V button
(8)
to activate laser line V1
(2)
. Press
a second time in order to activate laser lines V1 and V2
(3)
. Press another time to ac-
tivate all laserlines.
We advise to set the horizontal line on your working height.
Attention:
∙ Cross line lasers can only be used on tripods which are adjustable in height, such as
cranked or telescopic tripods.
∙ If the workplace is very brightly lit, e.g. out of doors, it may be necessary to use the
laser receiver.
Slope mode
Slide the on/off switch
(4)
to “OFF” so the laser beams are turned off and the trans-
portationlock is active.
Press 3 seconds on the H/V button
(8)
. The horizontal laser line will switched on. Now
sloped lines can be shown by balancing the laser device.
In order to use vertical lines, press the H/V button
(8)
to activate laser line V1
(2)
. Press
a second time in order to activate laser lines V1 and V2
(3)
. Press another time to acti-
vate all laserlines. Pressing a next time will switch off the laser.
IMPORTANT:
∙ In this mode, the laser lines no longer leveld automatically. The flashing laser lines
will remind you that the laser is not in automatic leveling mode.
