
Caution

Warning
AC outlet
Charger
Transmitter charging
LED
To transmitter
charging jack
To receiver
Ni-Cd battery
20
B
e
for
e
Using
Over current protection
Charging
jack
Cover
The transmitter charging circuit is equipped with an over cur-
rent protection circuit (1.7A). If the battery is charged with a
quick charger for other than digital proportional R/C sets, it
may not be fully charged.
When charging the HT5F1700B battery with the special char-
ger, allow about 15 hours for charging. If the transmitter has
not been used for some time, cycle the battery by charging
and discharging it two or three times.
Never plug it into an outlet of other than the indicated voltage.
0LUGGINGTHECHARGERINTOTHEWRONGOUTLETCOULDRESULTINANEXPLOSIONORlRE
Do not insert and remove the charger when your hands are wet.
It may cause an electric shock.
Always use the special charger or a quick charger for digital proportional R/C sets to charge a
digital proportional R/C set Ni-MH battery.
/VERCHARGINGA.I-(BATTERYCANRESULTINBURNSlREINJURIESORLOSSOFSIGHTDUETOOVERHEATINGBREAKAGEORELECTRO
-
lyte leakage.
Never try to recharge a dry cell battery.
The transmitter may be damaged or the battery electrolyte may leak or the battery may break.
When the charger is not in use, disconnect it from the AC outlet.
Do this to prevent accidents and to avoid overheating.
Charging
1
Plug the transmitter cord of the special char-
GER INTO THE CHARGING JACK ON THE REAR OF THE
transmitter.
2
Plug the charger into an AC outlet.
3
Check that the charging LED lights.
Charging The HT5F1700B Battery
T h e H T 5 F 1 7 0 0 B i s 5 - c e l l s , s o , w h e n c h a rg i n g t h e
HT5F1700B battery with Futaba CR-2000 charger, you have
to use the RX output side.
When using Futaba CR-2000
Summary of Contents for 4PK Super 2.4R
Page 1: ...INSTRUCTION MANUAL 1M23N20723 ...
Page 142: ......
