11
Receiver
R3106GF
The R3106GF receiver has 6 PWM channel outputs.
:KHQDSRZHUVXSSO\LVVXSSOLHGIURP
WKHPRWRUFRQWUROOHULWLVQWFRQQHFWHGك
5*)
/('
؟7KURWWOHVHUYRHQJLQH
؟0RWRUFRQWUROOHUHOHFWULF
%DWWHU\
6ZLWFK
؟$LOHURQVHUYR
؟(OHYDWRUVHUYR
؟5XGGHUVHUYR
؟QG$LOHURQVHUYRق)ODSHURQك
؟)ODSVHUYR
؟*HDUVHUYR
$QWHQQD
R3106GF is T-FHSS Air system, but the
telemetry function isn't equipped.
Receiver installation precaution
WARNING
The R3106GF receiver should be protected from
vibration by foam rubber, Velcro or similar mounting
methods. Protect from moisture.
Keep away from conductive materials to avoid short
circuits.
Be sure that the battery is the correct size for the
amount and type of servos being used. When using a
BEC, be sure that it is capable of delivering constant
voltage and can accept enough current that will be
used by the RX and servos.
Do not use a dry cell battery with this receiver.
Antenna installation precaution
WARNING
Don't cut or bundle the receiver antenna wire.
Don't bend the coaxial cable. It causes damage.
The antennas must be mounted in such a way to as-
sure they are strain relieved.
Keep the antenna as far away from the motor, ESC
and other noise sources as you possibly can.
Antenna installation for carbon fu-
selage
WARNING
You must leave 30mm at the tip of the antenna fully
exposed. The exposed antenna should be secured so
that it cannot move around or back inside of your air-
craft.
Connect precaution
DANGER
Don't connect a connector, as shown next.
• It will be a short-circuit, if it connected in this way. A
short circuit across the battery terminals may cause
abnormal heat, fire and burning.
Connection example
LED Indication
Green
Red
Status
Off
Solid
No signal reception
Solid
Off
Receiving signals
Alternate blink
Unrecoverable error (EEPROM, etc.)
5HFHLYHU
Do not insert either a switch
or battery in this manner.
