RATE GYRO INSTALLATION
NOTE: Be sure gyro is mounted as shown; for stabilization of the correct axis.
Helicopter • For rudder use
Connect connactor (A) to the receiver rud-
der channel and connector [B ] to the rudder
servo.
Aircraft - For aileron use
Connect connector (A) to the receiver aileron
channel and connector IB) to the aileron
servo.
Aircraft - For elevator (pitch shaft) use
Connect connector (A) to the receiver el-
evator channel and connector (B) to the el-
evator servo.
-When the gyro is mounted 180 out of phase, the direction of the correcting mix will be reversed. To correct
this situation, switch the internal reverse amp switch to "REV". After mounting the gyro to the fuselage,
recheck its direction of operation,
INSTALLING THE GYRO BODY
• The best mounting position is at the center of
gravity of the aircraft; however, it may also be
installed a short distance away from the center
of gravity.
• Install the gyro where there is little engine vibra-
tion.
• Attach the gyro to the fuselage with double-side
adhesive tape.
UK double sided adhesive
tape
(Clean the mounting sur
face and stick the gyro to
t h e with soft double-side
adhesive tape.
Use soft double-side
adhesive tape about 3mm
thick and 10mm wide.
CONTROL AMPLIFIER INSTALLATION
• Install the control amp where there is little engine
vibration, etc.
• Attach the control amp with double-side adhesive
tape.
Us* soft double-side adhesive tape about 3mm thick
and 10mm wide.
Double-side adhesive tape
Attach with soft double-side
adhesive tape.
