FUTABA FP-8SGAP, Instruction Manual

Page: 21 / 38

CHANNEL SELECT SWITCH
• This switch 48 selects the channel when setting
FS and HOLD functions. It also acts as the chan-
nel select switch for SERVO TEST function.
When switch 49 is set to RESET, the Channel
Select switch is used to designate the function
(ATV, FS, BFS memory, or ALL) to be cleared
by Buttons 46 and 47 . Note that the positions
on switch 48 have a different meaning when
the Function Select Switch is set on RESET.
This is summarized in the table below:
Channel select switch
Fig. 32
[48 Relationship among channel select switch
number, servo and reset.
No.
1.
2.
3.
4.
5.
6.
7.
8.
RESET &
TEST A L L
OFF
At switch [49] FS SELECT,
ATV, TESTA.B
Aileron
Elevator
Throttle
Rudder
Channel 5 switch (landing
gear)
Flaps
Channel 7 knob (spoiler)
Channel 8 lever (variable
pitch)
All the servos are
operated at servo
test.
Usually set to this OFF position.
At switch [49]
RESET
FS (fail safe)
ATV
BFS memory
FS, ATV, and BFS
memory are reset
simultaneously.
FUNCTION SELECT SWITCH
•This switch selects the function to be set (ATV,
FS, BFS memory) or test (A or B) to be per-
formed. It is also used in the RESET position to
clear ATV, FS, and BFS memory (in conjunction
with 4 6 , 4 7 , and 4 8 ) . Note: In RESET posi-
tion, the Channel Select Switch 48 is used to
designate the function(s) to be cleared.
Function select switch
Fig. 33
• Normally set it to OFF.
FS ALL
Switch to this position when setting fail safe
for all channels, FS is described in the "HOW
TO USE FS" section.
FS SELECT
This position allows setting of fail safe and
hold as described in the "HOW TO USE
FS" section.
ATV
This position allows setting ATV as describ-
ed in the "HOW TO USE ATV" section.
TEST A
This position allows servo test A as described
in the "SERVO TEST" section.
TEST B
This position allows servo test B as described
in the "SERVO TEST" section.
BFS MEMO SET
Switch to this position when setting the BFS
release point as described in the "BATTERY
FS MEMORY SETTING" section.
OFF
Normally set to this position.
PCM GREEN CHARACTER
NAMEPLATE AND RED
CHARACTER NAMEPLATE RC
SET COMPATIBILITY
When a red character nameplate transmitter and
a green character nameplate receiver are used as
a pair, only the 2 FS SELECT function of the
FUNCTION SELECT switch described above is
operative. In this case, switch is set to I FS
ALL and the receiver mode selector switch Is
set to FS. The fail safe function is ON for all
channels.
(When using the hold mode, set the receiver
mode selector switch to HOLD.)
When a green character nameplate transmitter
and red character nameplate receiver are used
as a pair, all the function of the transmitter are
operative.