Ver.1.0
4
Four symbols are used in the margin of the following section and throughout the manual to
indicate the level of hazard or information listed.
The symbols are defined as follows:
Indicates a hazard that
will
cause severe personal injury, death, or
substantial property damage if the warning is ignored.
Indicates a hazard that
can
cause severe personal injury, death, or
substantial property damage if the warning is ignored.
Indicates a hazard that will or can cause minor personal injury, or
property damage if the warning is ignored.
Indicates installation, operation, or maintenance information that is
important but not hazard-related.
Please read the following safety information carefully.
Some of these notices are
duplicated throughout the manual, in areas of associated content, for your benefit.
II.I
General Safety Hazards and Notes
Improper installation and/or operation of the FDP03TJ010/020 can
cause serious or fatal injuries to the operator or nearby persons and
cause damage to the FDP03TJ010/020, and any equipment it is used to
control.
Please read and understand this manual completely and the
manual of all equipment being controlled before attempting to operate
or install this system.
Always keep this manual at a location readily accessible to anyone
operating the system and related equipment. Ensure that all operators
have read and understood this manual, especially all safety and
operation procedures contained in it. Please refer to the section in this
manual titled
How to Obtain Help
for the contact that can supply
additional manuals or answers to questions not covered in this manual.
If this product is passed on to a different user, be sure that this manual
accompanies the product.
Be certain that the installer of this equipment reads and understands the
instruction manual of
the equipment that is being connecting to
before
attempting this installation.
The FDP03TJ010/020 should
NOT
be used in a manner in which
failure of the product or loss of the radio signal could cause damage to
the equipment being controlled, or to anything in the area in which
such equipment is located. All integrated control systems should be
designed for “fail-safe” operation so that a temporary or permanent loss
of signal will not endanger any person, critical process, or equipment
(refer to the beginning of the safety section for further explanation).
The system design should ensure that the equipment being controlled
will initial to its safest state in the event of signal loss.
The FDP03TJ010/020 contains no user serviceable parts. If the unit
requires service, contact your sales representative or local branch of
