28
SW-T Swash to throttle mixing (HELI only)
This function corrects slowing of engine speed caused by swashplate operation at aileron or elevator operation.
To activate swash to throttle mixing:
1. Enter the programming mode. Access the “
SW-T
” screen with the MODE key.
2. Push the DATA INPUT lever upward for 0.5 seconds. This will cause the flashing “
INH
”
display to change to a flashing “
ON
” display. Now the mixing is on.
NOTE:
The throttle to swash mixing function only operates in the Idle up flight mode.
3. Press the SELECT key to display the “
CHA
”. Use the DATA INPUT lever to set the
percentage of aileron to throttle mixing rate from 0% to 50%.
4. Press the SELECT key to display the “
CHE
”. Use the DATA INPUT lever to set the
percentage of elevator to throttle mixing rate from 0% to 50%.
SWSH Swashplate types selection & Swash AFR (HELI only)
This function can select from three swashplate types. Swash AFR can be set, if you choose 3-S or 3-E type
1-S
: Independent aileron, pitch and elevator servos linked to the swashplate. Most kits are 1-S type.
&RONT
%LEVATOR
0ITCH
!ILERON
!ILERON
0ITCH
34YPE
3-S
: With Aileron inputs, the aileron and pitch servos tilt the swashplate left and
right; with Elevator inputs, the three servos tilt the swashplate fore and aft; with Pitch
inputs, all three servos raise the swashplate up and down.
Front
Elevator
Pitch
(Aileron)
Aileron
(Pitch)
3-E Type
3-E
: With Aileron inputs, the aileron and pitch servos tilt the swashplate left and right;
with Elevator inputs, the servo tilts the swashplate fore and aft; with Pitch inputs, all
three servos raise the swashplate up and down.
