24
Initial Set-Up
Initial Set-Up
How to link the transmitter and the receiver
Each transmitter has an individually assigned, unique ID code. In order to start opera-
tion, the receiver must be linked with the ID code of the transmitter with which it is
being paired. Once the link is made, the ID code is stored in the receiver and no
further linking is necessary unless the receiver needs to be used with an other trans-
mitter. (For T/R set, the link is already done at factory.)
Link procedure
1. Bring the transmitter and the receiver close to each other, within one meter.
2. Turn on the transmitter.
3. Check the LED that is placed on the back side of the
transmitter to see if the RF signal is transmitted. When
the green LED is solid ON, the RF signal is transmitted.
*Please refer the table below for LED status vs transmitter's condition.
LED status vs transmitter's condition:
Parameter check for 0.5 seconds after power-on
Red: On
Transmitting signals
Green: On
F/S is activated by the F/S switch of the transmitter. (PPM mode)
Green: Blink
Unrecoverable failure (EEPROM, etc.)
Red and Green turn on alternatively.
4. Turn on the receiver.
5. Push the tactile switch of the receiver.
6. When the link is complete, the LED in the receiver changes to solid green.
*Please refer the table below for LED status vs receiver's condition.
LED status vs receiver's condition:
No signal reception
Red : On
Receiving signals
Green: On
Receiving signals, but ID is unmatched.
Green: Blink
Unrecoverable failure (EEPROM, etc.)
Red and Green turn on alternatively.
How to Set the F/S Position (PPM mode)
PPM mode only:
*HRS mode: Set the F/S function by the fail safe function menu.
1. Move and hold the throttle trigger to the F/S servo
position you want to set (slow side). Then push the
F/S switch on the transmitter.
*The LED blinks green.
Note: Always set the F/S position when turning on the transmitter power.
LED and
F/S switch
LED and
F/S switch
