FUST PRIMOTECQ TW730E, User Manual, Page: 52 / 60

If the door of the appliance or the small
door at the bottom is opened while the pro-
gramme is running, this button must be
pressed again after closing the door in or-
der to restart the programme from the point
at which it was interrupted. This button
must be depressed also after a power fail-
ure and after having reinserted the water
reservoir, if it has been emptied in the mid-
dle of a programme after lighting up of light
Water Tank .
In both cases the light of the Start/Pause
button flashes to remind you that the start
button needs to be pressed again.
Indicator lights
These lights indicate the following functions:
•
Trocken (Drying) light: This light indi-
cates that the appliance is in the drying
phase.
• Knitterschutz/Ende (Anticrease/End)
light: This light is on at the end of the
cooling phase, during the anticreasing
phase and at the end of the programme.
• Behälter (Water Reservoir) light: This
light indicates that the appliance is in the
drying phase. This light comes on at the
end of the programme to remind you that
the water reservoir must be emptied out.
If this light illuminates during a pro-
gramme this means that the water reser-
voir is full. The buzzer sounds, the pro-
gramme stops, the light of the Start/
Pause button flashes. This light comes
on also when the water reservoir is not
inserted correctly.
• Sieb (Filter) light: This light illuminates at
the end of the programme to remind you
that the filters must be cleaned.
• Wärmetauscher (Heat exchanger)
light: This light indicates that the heat ex-
changer fluff filters in the base of the ap-
pliance must be cleaned ,i.e. after each 3
drying cycles
Changing programme
To change a programme which has been
selected by mistake once the programme
has started, first turn the programme selec-
tor to
OFF position. The programme is
cancelled.
The programme can no longer be
changed directly once the programme
has started. If nevertheless there is an
attempt to change the programme on
the programme knob or if an function
button (excluding the
Signal (Buzzer)
button
4)
) is pressed, led on the START/
PAUSE button starts flashing tempora-
rily in red. The drying programme is not
however affected by this (laundry pro-
tection).
At the end of the programme
If the laundry is not removed at the end of
the cycle, the dryer performs an anticreas-
ing phase (duration: 30 minutes maximum).
If you do not remove the laundry, the dryer
will stop automatically at the end of the an-
ticreasing phase. Lights
Knitterschutz/
Ende (Anticrease/End) , Sieb (Filter) and
Behälter (Water Reservoir) remain lit and
the buzzer sounds for 2 minutes.
Turn the programme selector dial to
to
switch the machine off. Remove the laundry
from the drum and carefully check that the
drum is empty.
If you do not intend to carry out another
wash, close the water tap. Leave the door
open to prevent the formation of mildew
and unpleasant smells.
If you open and then close the door
before turning the selector dial to
all
the lights corresponding to the phases
making up the performed programme
come on.
After each use
• Clean the filters.
• Empty the water reservoir.
CLEANING AND MAINTENANCE
Emptying the water reservoir
Empty the water reservoir after every drying
cycle.
4) Only dryers with buzzer button
52