FUST Novamatic TW727.2 E, User Manual

Page: 10 / 44

At the beginning of the drying
cycle (first 3-5 min) there could
be a slightly higher sound level.
This is due to the compressor
starting up. This is normal for
compressor powered
appliances such as
refrigerators and freezers.
DAILY USE
Start a programme without
delay start
1. Prepare the laundry and load the
appliance.
CAUTION! Make sure that
when you close the door,
the laundry does not get
caught between the
appliance door and the
rubber seal.
2. Press the on/off button to activate the
appliance.
3. Set the correct programme and
options for the type of load.
4. Press the Départ/Pause (Start/Pause)
touch button.
The programme starts.
Starting the programme with
delay start
1. Set the correct programme and
options for the type of load.
2. Press the delay start button again and
again as necessary.
You can delay the start of a
programme by 3, 6 or 9
hours.
3. Press the Départ/Pause (Start/Pause)
button.
The LEDs (9H, 6H, 3H) change on each 3
hours.
Change a programme
1. Press the on/off button to deactivate
appliance
2. Press the on/off button to activate the
appliance.
3. Set the programme.
At the end of the programme
When the programme is completed:
• An intermittent acoustic signal
operates.
• The indicators Filtre (Filter) and Bac
plein (Tank) comes on.
• The Départ/Pause (Start/Pause)
indicator is on.
The appliance continues to operate with
the crease guard phase for approximately
other 30 minutes.
The crease guard phase prevents creases
from your laundry.
You can remove the laundry before the
crease guard phase is completed. We
recommend, for better results, that you
remove the laundry when the phase is
almost completed.
When the crease guard phase is
completed:
• The indicators Filtre (Filter) and Bac
plein (Tank) comes on.
• Départ/Pause (Start/Pause) indicator
goes off.
1. Press the on/off button to deactivate
the appliance.
2. Open the appliance door.
3. Remove the laundry.
4. Close the appliance door.
10