SWITCHING ON
Digital Rx Filter and Transmitter
Recognition Circuit
• Carefully push the jumper plug
supplied onto the signal pins of
channels 1 & 2.
• Connect the power supply and the
LED on the underside of the receiver
will start flashing quickly showing that
the filter has been switched on.
• Switch the receiver off and remove
the jumper plug.
SWITCHING OFF
Digital Rx Filter and Transmitter
Recognition Circuit
• Carefully push the jumper plug
supplied onto the signal pins of
channels 3 & 4.
• Connect the power supply and the
LED on the underside of the receiver
will start flashing slowly showing that
the filter has been switched off.
• Switch the receiver off and remove
the jumper plug.
It is very easy to tell whether the Digital Rx Filter and Transmitter Recognition Circuit
are turned on or off, because whenever the receiver is switched on;
•
If the LED on the underside of the Receiver flashes for 5 seconds then they
are switched on.
•
If the LED on the underside of the Receiver remains unlit then they are
switched off.
www.
l
ogic
rc
.com
Logic RC Limited
14 Hartham Lane
Hertford
SG14 1QN
United Kingdom
Be very careful not to bridge positive (+) to negative (-)
as this will cause a battery short circuit.
opErAtion
