Fusion 25664 Assembly Instructions Download Page 3

3

IN

ST

A

LL

A

TI

O

N & O

P

E

R

A

TI

O

N

B

A

T

TER

Y

 R

EP

LA

C

EM

EN

T

model no. 25664

Installation & Operation 

Note before installation: 

• 

Recommended install height between 5 ft. and 6 ft. 6 in from 

ground.
• 120° detection zone up to 9ft.

Installation (Figure 1)

 

 

Step 1: 

Measure and mark with a pencil where you will need to pre-

drill for screws (if required). 

Step 2:

 Secure with screws to post or rail through mounting holes 

from the front of the light.

Operation (Figure 2) 

Push the ON/OFF switch to turn on. Allow the unit to fully charge 

in direct sunlight for up to 2 days in the ON position. Once fully 

charged, your solar light will automatically turn on once it gets dark.

 

Note: Light will come on at low level (10 lumens) at dusk. Light 

goes to full power (80 lumens) for 20-25 seconds when motion 

is detected, then returns to low level.

 

Battery Replacement (Figure 3)

 

 

Step 1:

 Push the ON/OFF switch to turn off.

Step 2:

 Remove the screws from the battery compartment cover.

Step 3:

 Carefully lift the cover to access the battery compartment, 

being sure not to detach any of the connected wires.

Step 4:

 Replace the battery with an equivalent, new solar 

rechargeable battery (3.2V, lithium) ensuring the correct polarity is 

observed.

Step 5: 

Reassemble the unit by reversing the above procedure.

Step 6:

 Push the ON/OFF switch to turn on. Allow the unit to fully 

charge in direct sunlight for up to 2 days in the ON position.  Once 

fully charged, your solar light will automatically turn on once it gets 

dark.

CAUTION: Contains lithium-ion rechargeable battery. Battery 

must be recycled or disposed of properly. Do not mix old and 

new batteries. Do not mix alkaline, standard (carbon-zinc), 

or rechargeable batteries. Do not dispose of batteries in fire. 

Batteries may explode or leak.

figure 1

figure 3

ON/OFF

 

figure 2

MOTION 

SENSOR

Reviews: