14
GENERAL LAYOUT, CONT
’
D: POWER CORD & PLUG, LED LIGHTS AND LIGHT FIXTURES
3. Power Cord and Plug
•
Power cord and plug (for LED lights) locations vary
depending upon model.
•
Caution! You must plugged in an approved outlet!
4. LED Lights
•
LED lights are located at both header and shelving of case
(as shown below).
•
Check that ALL of the light plugs are properly connected to
the LED light.
•
Plug must be inserted ALL THE WAY into the LED light
orifice (with no gap) to work properly.
•
See
TROUBLESHOOTING
section in manual if LED lights
malfunction.
No Gap
Gap
5. LED Style Light Fixtures
Removal of faulty LED light:
•
LED lights rarely require change
-
out.
•
To remove faulty LED light, simply grasp light near
retaining spring and carefully pull away from its spring.
Disconnect plug from LED
’
s socket.
•
Contact Structural Concepts
’
Technical Service Depart-
ment for replacement parts (see Technical Service sec-
tion of this manual for information).
Replacement of LED light:
•
To replace LED light fixture, simply insert new LED light
at proper position (socket must be near plug). Carefully
snap into metal springs so LEDs are held firmly in place.
•
Note: LED light and plug must be connected in a
specific manner or they will not work.
A.
Certain plug designs
(“
barrel type
”)
merely require that
plug be pushed all the way in.
B.
Other plugs require
“
oval edge
”
of plug to
connect to oval edge of LED light.
•
See illustrations at right.
LED Light
Plug
LED
’
s Barrel
Shaped Insert
LED
’
s Oval Form
Plug
’
s
Oval Form
---
LED Plug & Light Fixture
---
Retaining
Springs
Plug
A
B
LED
’
s Barrel
Shaped
Insert
LED
Light
“
B
-
Shaped
”
LED Plug & Light Fixture
“
Barrel
-
Shaped
”
LED Plug & Light Fixture
