Furuno PP-505-FE, Operator'S Manual

Page: 9 / 24

3
2. REPLACEMENT OF THERMAL
PAPER
When the thermal paper runs out, the PAPER
LED blinks, printing stops automatically and the
aural alarm sounds for five seconds.
With 1 meter of paper remaining, a red paper
end mark appears on the paper. When the red
mark appears, replace the thermal paper as
shown in the procedure below.
1. Press the [FEED/MARK] key to draw out the
remaining thermal paper.
2. Pull the thermal paper cover forward and
take out the paper spool.
3. Curve the leading edge of the new roll paper
to ensure smooth feeding, and set the paper
spool to the new roll paper.
4. Insert the paper into the paper insertion slot
just above the paper container and press the
[FEED/MARK] key to feed out the paper.
5. Set the paper in the paper container.
6. Press the [FEED/MARK] key to confirm that
the paper is properly aligned.
If the paper comes out with its edges wrin-
kled, continue to press the [FEED/MARK]
key. Correct alignment will be made automat-
ically.
7. Close the thermal paper cover.
8. Press the [MODE] key to complete the
replacement of thermal paper. (The PAPER
LED goes off.)
Note: If the PP-505 receives data when there is
no paper it doesn't print them out after replacing
the thermal paper.
Remedy for paper jam
If the paper is jammed cut it off at the front panel
and rewind it into the paper container by hands.
REQUIRED THERMAL PAPER
Type: TP0340 (112 mmx40 m)
Code No.: 000-801-765
Be sure to use the specified
thermal paper.
RED mark
Reel
Thermal paper cover
Tape
Adhesive may
remain on paper
after tape is removed.
This may ca
u se a
paper jam, so c u t
paper to remove
adhesive.
Adhesive
Confirm that paper
is fed o
u t
thro u gh the slot.
Insertion slot