Furuno FM-8800D, Installation Manual

Page: 22 / 69

2. CONNECTIONS
2-4
Connecting the Remote Station without the Junction
Box
The remote station (or DMC Interface, Mic. Receptacle box, etc) can be connected directly
to the transceiver unit, using the D-sub connector supplied as installation materials.
Attach the connector to the cable as follows.
Shield tape (metal)
Fold back the armor,
and then wind the shield
tape along the edge of cable.
Cable clamp
Cable
Connector XM2A-3701 &
Housing case XM2S-3712
Attachment of connector
When the handset HS-2003 is not connected to the
Transceiver unit
When the handset HS-2003 is not connected to the transceiver unit, i.e.,always the remoted
handset is used, the following modification is necessary.
1. Dismount the cover of the transceiver unit by removing four screws at the rear panel and
two screws at the side.
2. Dismount the bottom cover by removing seven screws.
CPU board
05P0773
J15
3. Shorten between #1 and #2 of J15. The handset line of the HANDSET port becomes
always “ON HOOK”.
4. Assemble the unit.