Furuno FELCOM251, Installation Manual

Page: 43 / 122

2. INSTALLING THE SYSTEM
2-30
2.6.3 Installing the Communication Unit
To install the Communication Unit, do as follows:
1. Slide the Communication Unit into a 1U space in a 19” rack.
2. Mount two screws in each side through the holes in the front and fasten the screws
to the rack.
3. Connect all cables.
Make sure that the grounding requirements are met. See chapter 4.
2.7 Installing the Telport Extender (Option)
With the telport extender, you can extend the port for analog telephone/FAX connec-
tion of the Communication Unit from two ports to four ports.
Note: When install on a bulkhead or wall, install the unit with cables and connectors
facing downwards.
Mounting
1. Select a mounting location to fix the unit.
2. Make four pilot holes referring to the outline drawing at the back of this manual.
3. Set the unit to the pilot holes then fasten the self-tapping screws to fix the unit.
2.8 Installing the USB-RS232C Converter (Option)
To use the external equipment through RS-232C signal, an USB-RS232C converter
is required.
Note: When install on a bulkhead or wall, install the unit with cables and connectors
facing downwards.
Mounting
1. Select a mounting location to fix the unit.
2. Make four pilot holes referring to the outline drawing at the back of this manual.
Screw holes,
4 places x ø4.5