Furuno Felcom 30, Installation Manual, Page: 31 / 55

24
N-P-8DFB connector
Attach the connector to the antenna cable as shown below.
Outer Sheath
50
30
1
5
10
Armor
Inner Sheath Shield
Cover with heat-shrink tubing and heat.
Cut off insulator and core by 10 mm.
Twist shield end.
Slip on clamp nut,
gasket and clamp as shown left.
Clamp Nut
Gasket
(reddish
brown)
Clamp
Aluminum Foil
Trim shield here.
Fold back shield over clamp and trim.
Cut aluminum foil at four places,
90 from one onother.
Fold back aluminum foil onto shield
and trim.
Trim aluminum
tape foil here.
Insulator
Expose the insulator by 1 mm.
Expose the core by 5 mm.
Clamp Nut
Pin
Solder through
the hole.
Slip the pin onto the conductor.
Solder them together through the
hole on the pin.
Insert the shell into the pin.
Screw the clamp nut into the shell.
(Tighten by turning the clamp nut.
Do not tighten by turning the shell.)
Shell
(Dimensions in millimeters.)
How to attach the antenna cable connector N-P-8DFB
www.reelschematic.com
www.reelschematic.com