2. WIRING
2-3
2.2.4
Flexible waveguide
The connector at the antenna side is preattached to the flexible waveguide. The bend-
ing radius shown below must be observed to prevent damage to the waveguide.
E-bend: 200 mm, H-bend: 400 mm
2.3
How to Connect Cables
2.3.1
How to connect the antenna cable, serial cable, and LAN cable
1. Remove the cover of the unit.
2. Lay the cables in respective cable slots so their armors rest in the slots.
3. Connect the power line of the serial cable to the RF-TB Board as shown in the fig-
ure below.
LAN cable
Serial cable
Clamp
Antenna cable
Insertion
point
●
Antenna cable: TB803
●
Serial cable: TB803
TB803
TB801
Antenna cable
Serial cable
Wire
How to connect wires to WAGO connector
Press downward.
Terminal
opener
WAGO
connector
Twist
<Procedure>
1. Twist the cores.
2. Press the terminal opener downward.
3. Insert the wire to hole.
4. Remove the terminal opener.
5. Pull the wire to confirm that it is secure.
