Furuno FAR-3220W-BB, Installation Manual

Page: 77 / 185

2. WIRING
2-41
2.6 Monitor Unit
For how to wire the monitor unit, see the operator’s manual supplied with the monitor
unit. Also, for resolution and image data output settings, see the Instruction Manual
(E32-01305-*).
Mounting considerations
 Standard type
• Connect the radar main monitor to the DVI1 and COM1 ports.
• Connect the sub radar monitor to the DVI2 and COM2 ports.
 VDR connection
To connect a VDR, it is necessary to output data in analog format. See the Instruc-
tion Manual (E32-01305-*). To connect a VDR to the DVI3 port, use the optional
DVI-BNCX5-L2000 cable to output the RGB signal from the DVI-I. See the opera-
tor’s manual supplied with the VDR. Adjustment of the output is necessary.
Menu setting
The [INSTALLATION SETTING] menu appears only when the power is turned on for
the first time after installation of the monitor unit.
Adjust the settings referring to the following table.
*: [DVI PWR SYNC] is the slide switch at the bottom rear of the monitor unit. Confirm
that this switch is set to [ON] (default setting). See Slide switch below for details.
Slide switch
Set the slide switch to “ON” (default setting). This setting automatically powers the
monitor unit on or off according to the DVI signal input. The power switch of the mon-
itor unit is inoperative.
Note: The OFF position provides control of the monitor unit power with the power
switch of the monitor unit.
EXT BRILL
CTRL
SERIAL BAUD
RATE
COLOR
CALIBRATION
KEY
LOCK
DVI PWR
SYNC*
RS-485 4800bps ON ON ON
INSTALLATION SETTING
EXT BRILL CTRL
SERIAL BAUDRATE
COLOR CALIBRATION
KEY LOCK
SAVE AND EXIT
RS-485
4800bps
ON
ON
YES
(OFF/DVI1/DVI2/RS-232C/RS-485/USB)
(4800/9600/19200/38400)
(OFF/ON)
(OFF/ON)
(NO/YES)
Menu
Menu item