Furuno DS-60, Installation Manual

Page: 27 / 74

1. INSTALLATION
1-21
How to change orientation of the front cover of DS-605
The front cover of the DS-605 can be oriented up, down, right or left. To change the
orientation of the front cover, do the following.
Note: Set the front cover so the FURUNO logo on the cover is right side up. The drain
hole must be down.
1. Remove eight screws from two hinges.
2. Remove two screws from the latch.
3. Remove the hinges and the hidden lids for fixing hole of latch in consideration of
the opening direction.The hidden lids for fixing hole of latch are taped on each
side.
4. Orient the front cover as desired and fix the hinges and latch.
1.7 Remote Controller RD-501/Dimmer Controller
RD-502 (option)
The optional remote controller RD-501 and dimmer controller RD-502 can be flush
mounted in a panel. The size and the mounting procedure are shared by RD-501 and
RD-502. For the mounting location, refer to the mounting considerations for the dis-
play unit in section 1.2.
Note: Before you fasten the display unit to the cutout, first connect the cables referring
to chapter 2.
1. Make a cutout in the mounting location (88 mm (width) x 76 mm (height)).
2. Make four holes of 4 mm diameter in the locations indicated in the illustration be-
low.
3. Set the remote controller or dimmer controller to the cutout. Insert four binding
head screws (M3x12) from the front side then fasten the unit with four sets of flat
washers, spring washers and hexagonal nuts from the rear side.
Hinge
Latch
Screws for hinge
Hidden lids for
fixing hole of latch
(four sides)
DISP UNIT MODE
REMOTE CONTROLLER
RD-501
88 ± 1.0 (3.46”)
86 ± 0.5 (3.39”)
76 ± 1.0 (2.99”)
Fixing hole (4- 4)
86 ± 0.5 (3.39”)