Furuno DRS12ACM, Installation Manual

Page: 24 / 52

17
3. Insert wires of cable
M12-05BFFM (
φ
6)
or
CB-05BFFM (
φ
10)
to the NMEA connector inside the
radar sensor, consulting the label on the connector for location. As for shield, use the cable
clamp shown below.
Cable M12-05BFFM ( φ 6) CB-05BFFM ( φ 10)
Clamp Use the clamp pre-attached inside the radar
sensor. Use the clamp supplied with the optional gasket
(Type: OP03-203,
Code No.: 001-025-290)
15
5
CB-05BFFM cable
370
CB-05BFFM cable
20
65
15 (Area fastened with the cable clamp)
Wind vinyl tape.
(supplied)
Fabrication of CB-05BFFM cable
Fasten the cable tie (supplied) within
15 mm from the end of vinyl sheath.
Shield
Zoom u p
Attach the ca b le clamp
u sing this scre w for CB-
05BFFM ca b le. (Face
projecting part do w n.)
Ca b le clamp
Location of the ca b le clamp