Page 5 of 5
Turn right (clockwise) to tighten
I.
The 2 support rails (#5) are already attached behind the dresser
(#1). Position the support rails (#5) vertically to align with the pre-
drilled holes of the dresser (#1) and the mirror (#4).
II. Prepare 6 bolt assemblies by inserting FIRST the lock washer
(#B) onto the bolt (#A) and then the flat washer (#C) onto the
SAME bolt (#A), in that order. The other 2 bolt assemblies are
already attached to the support rails (#4) from the factory.
III. Insert the bolt assemblies through the support rails (#5) and
secure those bolts using an Allen wrench (#D) to lock with the
dresser (#1) and the mirror (#4). Tighten all bolts, including those
that were already attached from the factory.
IV. If needed, adjust the leveler according to the ground level. To
lower or to raise the support leg, turn the leveler clockwise or
counterclockwise, respectively.
#A x 8 pcs
#B x 8 pcs
#C x 8 pcs
ASSEMBLY IS COMPLETED
Summary of Contents for Syracuse CM7129D
Page 2: ...Page 2 of 5...
