Turn right (clockwise) to tighten
Page 5 of 5
#E x 6 pcs
ASSEMBLY IS COMPLETED
1.
Align the 3 assembled
slats (#5) with the pre-
drilled holes on the side
rails (#3).
2.
Secure 2 screws (#E)
onto the ends of each
assembled slat (#5) using
a Phillips screwdriver to
tighten them with the side
rails (#3).
3.
If needed, adjust the
levelers according to the
ground level. To lower or
to raise the slat support
leg, turn the levelers
clockwise or
counterclockwise,
respectively.
I.
Align the threaded end of the slat support leg (#6) with the
pre-drilled hole on the slat (#5) and tighten by hand until
secured.
II.
Repeat the process above to assemble the remaining 2
slat support legs (#6) onto the remaining 2 slats (#5).
Adjust the levelers according to the
ground level on Step 4.
Summary of Contents for Pioneer CM7449CK
Page 2: ...Page 2 of 5...
Page 7: ...Page 2 of 5...
