Page 6 of 6
Turn right (clockwise) to tighten
#B x 8 pcs
#D x 8 pcs
#E x 8 pcs
I.
With the help of another person, carefully place the table top (#1)
facing down on a protective surface. Align the assembled
legs/shelf with the pre-drilled holes on the table top (#1).
II.
Prepare 8 bolt assemblies by inserting FIRST the lock washer (#E)
onto the bolt (#B) and then the flat washer (#D) onto the SAME bolt
(#B), in that order.
III. Insert the bolt assemblies through the holes of the brackets (#G)
and secure those bolts using the Allen wrench (#F) to lock them
with the table top (#1).
#G
To install the batteries (not included),
remove the screw that holds the battery
cover by using a Phillips screwdriver.
Install new AA-size 1.5-volt alkaline
batteries with correct polarity (
,
) by
following the illustration inside the battery
cover. Close the battery cover and tighten
back the screw.
Caution:
Use batteries of the same type.
Do not mix old and new batteries.
Do not mix alkaline, standard (carbon-zinc), or rechargeable (nickel-cadmium) batteries.
Do not use rechargeable batteries.
Do not try to recharge non-rechargeable batteries.
Remove exhausted or corroded batteries.
If light is not used for more than a week, remove the batteries to prevent depletion and corrosion.
Place the glass top (#4) onto the table top
(#1). Make sure the table is rested on a flat
surface and does not feel loose or wobbly. If it
does, double check that the bolts/screws are
secured and properly tightened.
#1
Summary of Contents for Luminar II CM3559PT
Page 2: ...Page 3 of 6...
