Turn right (clockwise) to tighten
Page 4 of 5
#B x 2 pcs
#G x 2 pcs
#H x 2 pcs
I.
Carefully place the glass top (#1) facing down on a protected
surface. Insert the 2 threaded studs (#B) into the pre-drilled
holes on the center of the glass top (#1).
II.
Place the pedestal (#2) over the 2 threaded studs (#B). Then
place 2 large flat washers (#H) over the 2 threaded studs (#B).
III.
Secure the 2 hex nuts (#G) onto the same threaded studs using
the hex wrench (#F) to tighten the parts together.
#A x 4 pcs
#C x 4 pcs
#E x 6 pcs
I.
Align the base (#3) with the
pre-drilled holes on the other
side of the pedestal (#2).
II.
Prepare 4 bolt assemblies by
inserting the small flat
washer (#C) onto the bolt
(#A).
III.
Insert the bolt assemblies
through pre-drilled holes of
the base (#3) using the Allen
wrench (#D) to lock them
with the pedestal (#2).
IV.
Align the threaded ends of
the 6 levelers (#E) with the
pre-drilled holes on the base
(#3) and tighten by hand
until secured.
Turn right (clockwise) to tighten
Adjust the levelers according
to the ground level on Step 4.
Summary of Contents for Lodia CM4825-C
Page 2: ...Page 2 of 5...
