Furniture of America HFW-1650C6, Assembly Instructions Manual

Page: 7 / 12

STEP : 1
Hardware 1 x 4 pcs
Hardware 4 x 16 pcs
Hardware 10 x 2 pcs
Hardware 11 x 2 pcs
Hardware 12 x 1 pc
Hardware 16 x 4 sets
ASSEMBLY INSTRUCTIONS
Page 7 of 12
Identifying Drawer's Rails (a.k.a. Runners, Glides, Slides or Guides)
An assembly of ONE drawer requires a set of 4 different rails: right panel rail, left panel rail, right
drawer rail and left drawer rail. To identify which rail belongs to which part, please read completely
first before assembling.
To Determine Right/Left Panel Rail: Place the panel rail flat on its back with the roller position on
the left hand side. If there are two holes above the roller and the other end is slightly downward angle
then it is the LEFT PANEL RAIL. If there are two holes below the roller and the other end is slightly
upward angle, then it is the RIGHT PANEL RAIL. The right and left panel rails are mirror image of
each other . If needed, label or separate each rail for easy identification.
To Determine Right/Left Drawer Rail: Place the drawer rail with the round and oval holes resting
flat on the surface with its roller on the right hand side. If the roller is facing the top, then it is the
LEFT DRAWER RAIL and if the roller is facing the bottom, then it is the RIGHT DRAWER RAIL. The
right and left drawer rails are mirror image of each other. If needed, label or separate each rail for
easy identification.
Mounting the Panel Rail: The panel rail is constructed to be mounted flat. Make sure the roller is
position on the front of the panel and the screw holes are aligned with the pre-drilled holes of the
panel.
Mounting the Drawer Rail: The drawer rail is constructed to be mounted on the side of the drawer .
Make sure the roller is position on the SIDE REAR of the drawer and the screw holes are aligned
with the pre-drilled holes on the side of the drawer .
11
10
12
X2
H
X2
X2
Dowel hole
F
G
16