Furniture of America Colman CM3615T-60, Assembly Instructions

Page: 4 / 4

Page 4 of 4
I. With the help of another person,
carefully place the table top (#2)
facing down on a protected surface.
II. Align the assembled leg stands (#1)
with the pre-drilled holes on the table
top (#2).
III. Secure 6 screws (#B) through the 2
leg stands (#1) and 4 screws (#B)
through the 2 aprons (#3) using a
Phillips screwdriver to secure them
with the table top (#2).
IV. Carefully place the completed table
upright. Make sure the table is rested
on a flat surface and does not feel
loose or wobbly. If it does, double
check that the bolts/screws are
secured and properly tightened.
#A x 20 pcs
I. Align the 2 aprons (#3) with the
brackets of the leg stand (#1).
II. For each bracket of the leg stand
(#1), insert 2 bolts (#A) through the
bottom of the bracket and 2 bolts
(#A) through the side of the bracket
using the Allen wrench (#C) to
secure them with the apron (#3).
III. Align one end of the leg stand
support (#4) with the pre-drilled
holes on the center of the same leg
stand (#1).
IV. Insert 2 bolts (#A) through the
bracket of the leg stand support (#4)
using the Allen wrench (#C) to
secure them with the leg stand (#1).
V. Repeat the process above to
assemble the other leg stand (#1)
onto the other ends of the 2 aprons
(#3) and the leg stand support (#4).
Turn right (clockwise) to tighten
ASSEMBLY IS COMPLETED
Turn right (clockwise) to tighten
#B x 10 pcs